Run ended
2018-11-24 17:26:30.516423
Current: 2 [2] Completed: 100% [0s Tot: 0s ]
Grbl 1.1f ['$' for help]
ok
Run ended
2018-11-24 17:26:33.538935
Current: 2 [2] Completed: 100% [0s Tot: 0s ]
Grbl 1.1f ['$' for help]
在 linux 控制台中一次又一次
Ignoring machine stream request, because of state: Idle True
Controller state changed to: Idle (Running: False)
Job done. Purging the controller. (Running: False)
Stream requested by CYCLE START machine button
Will clean after this operation
.jpg "bCNC仍在做任何事情 #1064"){kind=avatar}
我不能做任何事情 bCNC stil 循环做 sometring 连接 grbl 机器后停止 没有
在 bCNC 控制台循环中打开 gcode 文件
在 linux 控制台中一次又一次